TRACTOR PARTS Allis Chalmers Case & David Brown Farmall & International Ferguson Ford & New Holland John Deere Massey Ferguson Massey Harris Minneapolis Moline Oliver & Cockshutt Kubota / Yanmar

TRACTOR MANUALS

Allis Chalmers	Case	Farmall IH	Ford 8N,9N,2N	Ford
Ferguson	John Deere	Massey Ferguson	Minn. Moline	Oliver

Tractor Talk Discussion Forum

11.5hp wiring diagram needed

Welcome Guest, Log in or Register

Author

chris sweetland

12-09-2005 08:08:18

Report to Moderator

i am looking for a wiring diagram to an 11.5hp briggs model 259707 type 4026-01 thanks

[Log in to Reply] [No Email]

chris sweetland

12-09-2005 09:20:56

Report to Moderator

Re: 11.5hp wiring diagram needed in reply to chris sweetland, 12-09-2005 08:08:18

ok the wires burned up i guess i should have told the story i can make a wireing harness no problem its just when the wires burned (small fire leaky gas tank wish i knew but it cought the insulation on fire) and now it dosent have spark anymore if you can get me to get spark i can manage the rest

[Log in to Reply] [No Email]

12-09-2005 13:33:46

Report to Moderator

Re: 11.5hp wiring diagram needed in reply to chris sweetland, 12-09-2005 09:20:56

Unhook the wire at the coil that kills it, if that don't help, you probably have a bad coil wire and need a new coil

[Log in to Reply] [No Email]

12-09-2005 08:33:07

Report to Moderator

Re: 11.5hp wiring diagram needed in reply to chris sweetland, 12-09-2005 08:08:18

There is no "wiring diagram" for Briggs engines other than what is in repair manual. Most wiring diagrams are part of the tractor parts/service manuals and they can be reeaallll fun to get. We had an MTD 2 weeks ago that I neded one for, MTD said "don't exist" How do you fix it with that attitude from the manufacturer??? But it is MTD we are talking about.

[Log in to Reply] [No Email]

buickanddeere

12-09-2005 08:30:04

Report to Moderator

Re: 11.5hp wiring diagram needed in reply to chris sweetland, 12-09-2005 08:08:18

It's likely just two AC lines coming off the stator and running to a rectifier or rectifier/voltage regulator. Sometimes two pairs of leads are ran out from the stator. Two AC wires to lights and two AC wires to the DC recitifier/regulator charging system. Magneto or coil ignition? Magneto shorts out to stop the engine. The coil ignition opens the circuit. Most of these can be wired up just using some measurements with a muiltimeter and some investigation. If a rectifier/regulator cannot be found. Just a bridge rectifier and a zenor diode from Radio Shack does the same.

[Log in to Reply] [No Email]

12-09-2005 08:45:19

Report to Moderator

Re: 11.5hp wiring diagram needed in reply to buickanddeere, 12-09-2005 08:30:04

All Briggs engines are magneto type igntion and these smaller ones(single cyliner) normally do not have a regualtor/rectifier. The either one lead for DC only or 2 leads one for AC one for DC coming out under flywheel. The DC has a diode in it.

[Log in to Reply] [No Email]

[Options] [Printer Friendly] [Posting Help] [Return to Forum] [Log in to Reply]

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]

Home | Forums

Copyright © 1997-2023 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters

Website Accessibility Policy