Welcome! Please use the navigational links to explore our website.
PartsASAP LogoCompany Logo Auction Link (800) 853-2651

Shop Now

   Allis Chalmers Case Farmall IH Ford 8N,9N,2N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver

Tractor Talk Discussion Forum

pulley removal, mover deck spindle

Welcome Guest, Log in or Register
Author 
toakley

11-12-2005 14:27:47




Report to Moderator

Any suggestions, on how to remove the drive belt pulley thats seems to be rusted to the mover deck blade spindle? I have to replace the spindle shaft bearings.i've tried wheel pullers, heat & rust buster solvent. I'm at a stand still. The mover deck is off my AC B207. Any help? Thanks - Tom




[Log in to Reply]   [No Email]
Bob

11-12-2005 23:41:18




Report to Moderator
 Re: pulley removal, mover deck spindle in reply to toakley, 11-12-2005 14:27:47  
Can you remove the whole spindle assembly, and support the bearing holder ("quill") in a press, and then push the spindle out of the pulley and the bearings at the same time?

I have done that on Deere mower spindles with the pulley stuck. I shears off the woodruff key as the spindle gets pressed through the bearings, but a new key is a lot cheaper than if I pulled on the pressed steel pulley, and wrecked it.

[Log in to Reply]  [No Email]
[Options]  [Printer Friendly]  [Posting Help]  [Return to Forum]   [Log in to Reply]

Hop to:


TRACTOR PARTS TRACTOR MANUALS
We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]

Home  |  Forums


Copyright © 1997-2023 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters

Website Accessibility Policy