Will a 1256 Farmall cab fit a 656 Farmall?

I bought mine complete for $500. It makes a nice looking unit on 656. I had to fabricate four mounts. Two to clamp on each axle carrier, and two made from 3x3x3/8 angle coming back from clutch housing. At the time, I could see this cab was going to create problems servicing batteries, so I built two battery boxes mounted on engine frame rails just ahead of my front cab supports. This allowed me to install much heavier batteries.

Closing in the floor and around hood were quite easy. The big problem and I never did do this would have been closing in the bottom rear around 3 point hitch. I was quite happy I was doing early spring planting and late fall work out of close to freezing temps. I did have the heater hooked up. Mid summer I used to take doors off and back window out. Those first old cabs weren't dust proof very long, so best in dusty seasons to just let good air flow deal with it.

Can't say for sure, but weren't most of the cabs back then open-bottomed, aftermarket hang ons done by the dealers?

If so, it'll sure go on the 656, but you have to remember that the 1256 is a large chassis tractor and the 656 is the little guy.

All the mounts are gonna be different and also, around that hood area for sure.

Hope you get 'er figured out.

Allan