TRACTOR PARTS Allis Chalmers Case & David Brown Farmall & International Ferguson Ford & New Holland John Deere Massey Ferguson Massey Harris Minneapolis Moline Oliver & Cockshutt Kubota / Yanmar

TRACTOR MANUALS

Allis Chalmers	Case	Farmall IH	Ford 8N,9N,2N	Ford
Ferguson	John Deere	Massey Ferguson	Minn. Moline	Oliver

Discussion Forum

Ford tractor

Welcome Guest, Log in or Register

Author

Lanny Sweet

03-22-2003 06:13:37

Report to Moderator

I can't seem to find out exactly what model tractor I have. The hood says Ford 900, but the previous owner says it is a 960. The serial number is 5668157-01.It has a four cylinder gas engine, narrow front end, five speed transmission, live pto, and three point hitch.
It's supposed to be either a 1963 or 1964.

If anyone knows something about this tractor I would greatly appreciate it.Thanks

[Log in to Reply] [No Email]

paul

03-24-2003 12:20:12

Report to Moderator

Re: Ford tractor in reply to Lanny Sweet, 03-22-2003 06:13:37

It sounds like the middle number will be a 6 - "x6x" because of the 5 speed & live pto.

'xx0' were not made in the 60's, it would be a late 50s tractor.

Or, it would be a 'xx1' model if it's newer.

The 9 tells us it is a taller, row-crop model with the bigger engine, with the rear axle stepped down to the wheels.

You will find the serial number stamped (by hand so it's uneven) into the cast lobe right below the air cleaner. Wet your finger & rub across it, they can be quite light. You should see the full model number (such as 960) along with a few other numbers & letters.

Often they have power steering, but I guess it was still an option. Do you have the older vane hyd pump, or the newer piston pump? (In front of the brake pedals.)

--->Paul

[Log in to Reply] [No Email]

Stan(PA)

03-22-2003 12:06:23

Report to Moderator

Re: Ford tractor in reply to Lanny Sweet, 03-22-2003 06:13:37

It's a 900 SERIES, MODEL 960. The 6 means 5speed with live PTO. The 900 series was made until 1957, and then became 901. Serial # doesn't make sense to me, maybe somebody else on here can figure it out. You'll find "serial numbers" on the left column of this screen. This site has tons of information if you look around.

[Log in to Reply] [No Email]

Zeke Hurd

12-13-2003 12:28:13

Report to Moderator

Re: Re: Ford tractor in reply to Stan(PA), 03-22-2003 12:06:23

Hi, Folks.
I'm looking at a 901 Powermaster, 5 SPD, 4 cyl. Diesel, with "live PTO".
Can anyone tell me the approximate HP?
Also, it has the narrow front end. Could I buy a wide front end someplace to replace the narrow? If so, would anyone know where to begin to look?

Thank you very much.
Sincerely,
Zeke Hurd

[Log in to Reply] [No Email]

[Options] [Printer Friendly] [Posting Help] [Return to Forum] [Log in to Reply]

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]

Home | Forums

Copyright © 1997-2023 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters

Website Accessibility Policy