Welcome! Please use the navigational links to explore our website.
PartsASAP LogoCompany Logo Auction Link (800) 853-2651

Shop Now

   Allis Chalmers Case Farmall IH Ford 8N,9N,2N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver

Farmall & IHC Tractors Discussion Forum
:

Super-H Hyd lift will not hold up kelly Loader

Welcome Guest, Log in or Register
Author 
VA Gasman

04-14-2008 14:43:50




Report to Moderator

Moved 3 logs this AM with Kelly loader on H worked fine. Moved 2 bales of hay worked fine. Went to move it later on and bucket will not stay up. Cylinders leak down. Will lift fine but will not stay in up position. Just as soon as you stop the lifting sequence it will start slowly down. Not as fast as if you have released pressure. What should I look for ?
Thanks, Randy




[Log in to Reply]   [No Email]
Janicholson

04-15-2008 09:27:34




Report to Moderator
 Re: Super-H Hyd lift will not hold up kelly Loader in reply to VA Gasman, 04-14-2008 14:43:50  
Two specific things:
If the loader has double acting cylinders on the lift, and the top of the cylinders are used for oil storage to supplement the resivoir, then one prospect is one of the cylinder is bypassing fluid past the piston. (it only takes one of them to leak to cause the problem). If the cylinders are single acting, the bypassed oil will be trapped above the cylinder, and either cause the cylinder to stop at some point short of extension, or squirt oil out at the point where the ram comes out.
If the cylinders are double acting, and not connected as a resivoir, the oil would come out of the top cylinder port.

The other possible issue might be either a faulty or stuck relief valve in the pump, or a leaky control valve allowing hold pressure to bleed off into the resivoir.

Test. Hold the loader up in the air with a chain fall or other reliable adjustable lift. Cap the line going to the valve (lift line). Let the loader have its own wt. and if it drifts down, it is cylinder bypass. (be careful of the loader falling, be safe)
If it stays up, it is a valve or pressure regulator problem. JimN

[Log in to Reply]  [No Email]
[Options]  [Printer Friendly]  [Posting Help]  [Return to Forum]   [Log in to Reply]

Hop to:


TRACTOR PARTS TRACTOR MANUALS
We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]

Home  |  Forums


Copyright © 1997-2023 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters

Website Accessibility Policy