TRACTOR PARTS Allis Chalmers Case & David Brown Farmall & International Ferguson Ford & New Holland John Deere Massey Ferguson Massey Harris Minneapolis Moline Oliver & Cockshutt Kubota / Yanmar

TRACTOR MANUALS

Allis Chalmers	Case	Farmall IH	Ford 8N,9N,2N	Ford
Ferguson	John Deere	Massey Ferguson	Minn. Moline	Oliver

Farmall & IHC Tractors Discussion Forum

f20 brakes convertible?

Welcome Guest, Log in or Register

Author

casered

10-30-2007 14:54:07

Report to Moderator

My grandfather just picked up a 1937 F20NT over the weekend. It has hand brakes on it now and I wondered if it was possible to convert it to foot brakes and if so what all was required to do this? We got some extra parts with it as it"s not all together and there is a set of brkae pedals but I am not sure if they fit or not. My dig camera is dead at the moment so I can"t get any photos till I get some batteries for it. Just think it would be easier for my pap to operate with foot brakes and less likely to get out of control. Thanks for any help.

[Log in to Reply] [No Email]

casered

10-30-2007 19:12:18

Report to Moderator

Re: f20 brakes convertible? in reply to casered, 10-30-2007 14:54:07

Could someone post a closeup pic if possible of the brake assembly on a foot brake equipped unit. I have looked thru all the books and literature I have on these and cannot find a picture that shows the brake area up close and clear enough to know if I allready have the right parts or not. Thanks for the reply Cowman.

[Log in to Reply] [No Email]

Nebraska Cowman

10-31-2007 04:54:59

Report to Moderator

Re: f20 brakes convertible? in reply to casered, 10-30-2007 19:12:18

here's a closeup of the lower part of the pedals. A shaft goes under the tractor to operate the left side.

[Log in to Reply] [No Email]

casered

10-31-2007 15:54:10

Report to Moderator

Re: f20 brakes convertible? in reply to Nebraska Cowman, 10-31-2007 04:54:59

Thanks again for the picture. If I need any of the parts I will let you know.

Thank you again.

[Log in to Reply] [No Email]

Nebraska Cowman

10-30-2007 15:36:37

Report to Moderator

Re: f20 brakes convertible? in reply to casered, 10-30-2007 14:54:07

Yes, there were aftermarket foot brakes that are not too hard to install. IH made some with foot brakes the last couple years. I have both types available.

[Log in to Reply] [No Email]

[Options] [Printer Friendly] [Posting Help] [Return to Forum] [Log in to Reply]

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]

Home | Forums

Copyright © 1997-2023 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters

Website Accessibility Policy