Welcome! Please use the navigational links to explore our website.
PartsASAP LogoCompany Logo Auction Link (800) 853-2651

Shop Now

   Allis Chalmers Case Farmall IH Ford 8N,9N,2N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver

Farmall & IHC Tractors Discussion Forum
:

560 clutch problems

Welcome Guest, Log in or Register
Author 
Tom Graham

08-04-2007 11:56:17




Report to Moderator

My mechanics are putting a clutch and pressure plate (along with a rebuilt engine) into my 560 gas. When they had it bolted together they could not get the pressure plate to release far enough to disengage the clutch. I put a clutch and pressure plate in about 30 years ago and had the same problem; my fix was to install a small washer between the pressure plate and flywheel on each bolt that fastens the pressure plate to the flywheel. What are we missing?

[Log in to Reply]   [No Email]
The tractor vet

08-04-2007 13:13:02




Report to Moderator
 Re: 560 clutch problems in reply to Tom Graham, 08-04-2007 11:56:17  
Did they check the STEP to face distance on the flywheel it sounds like the step is off if ya have to place washers under the plate .



[Log in to Reply]  [No Email]
Larry in Mo

08-04-2007 12:37:01




Report to Moderator
 Re: 560 clutch problems in reply to Tom Graham, 08-04-2007 11:56:17  
First off I'd check to make sure all the fingers on the pressure plate are the correct length and height. Then go thru the correct clutch linkage adjusting procedures including the T/A linkage. Also make sure the clutch disk is installed with the long side of the hub pointed in the correct direction. How about throw-out bearing? LE



[Log in to Reply]  [No Email]
[Options]  [Printer Friendly]  [Posting Help]  [Return to Forum]   [Log in to Reply]

Hop to:


TRACTOR PARTS TRACTOR MANUALS
We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]

Home  |  Forums


Copyright © 1997-2023 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters

Website Accessibility Policy