Welcome! Please use the navigational links to explore our website.
PartsASAP LogoCompany Logo Auction Link (800) 853-2651

Shop Now

   Allis Chalmers Case Farmall IH Ford 8N,9N,2N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver

Farmall & IHC Tractors Discussion Forum
:

Head bolt Torque and sequence

Welcome Guest, Log in or Register
Author 
farmall newbie

06-24-2007 16:43:04




Report to Moderator

for Farmall M, serial number fbk249103. Please reply to skitterick@juno.com or post here. Have need for the info as I am ready to re-install the head. Bolt sequence and torque in ft lbs, please.




[Log in to Reply]   [No Email]
El Toro

06-24-2007 17:08:19




Report to Moderator
 Re: Head bolt Torque and sequence in reply to farmall newbie, 06-24-2007 16:43:04  
I have the torque listed at 110-ft-lbs. I don't have a sketch of the tightening sequence, but you can start in the middle of the head and tighten in both directions. You probably should use 4 different torques starting around 30-ft-lbs and then to 60, 90 and 110 ft-lbs. You need to keep to come back to the middle of the head when you increase the torque and keep tightening in both directions. You probably should retorque the bolts at 110-ft-lbs after the engine has been run.
Check the valve lash too. Hal

[Log in to Reply]  [No Email]
[Options]  [Printer Friendly]  [Posting Help]  [Return to Forum]   [Log in to Reply]

Hop to:


TRACTOR PARTS TRACTOR MANUALS
We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]

Home  |  Forums


Copyright © 1997-2023 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters

Website Accessibility Policy