Good day My last post on this subject was that my newly installed alternator decided to pump out about 17 volts continuously so I replaced the alternator with another rebuilt and every thing was cool. I asked a few questions on here about the old alternator and got some good information. So I wanna thank those guys.El Toro - thanks for leading me to the site for regulators. I got the part number, went to NAPA and they got me one for about 8 loonies. Went to your suggested site for replacing it, not too bad, they forgot to tell me about the springs and brushes popping out when I pulled the rotor! Not to worry, installed new regulator, got brushes back in holders and held them with little piece of wire while I assembled the alternator. Bob M - your advice and your wiring diagrams are superb. I have installled a bigger diode and a 10 ohm resistor on the tractor now. Yugrcart - You were bang on about "The Source" here in Canada. I went on line, found them, they had diodes and resistors, I ordered them and they delivered them to my doorstep by Purolator for 2 loonies! So, the end result - after I installed the regulator in the alternator, I tried it out on the C and it works perfectly. Now I have a spare alternator for another tractor - hmmm, am I gonna have to buy something else?!!!!! !!! Thanks guys!!
|