Welcome! Please use the navigational links to explore our website.
PartsASAP LogoCompany Logo Auction Link (800) 853-2651

Shop Now

   Allis Chalmers Case Farmall IH Ford 8N,9N,2N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver

Farmall & IHC Tractors Discussion Forum
:

Farmall 560 Diesel (turn up fuel)

Welcome Guest, Log in or Register
Author 
Justin Wiseman

01-21-2006 11:05:06




Report to Moderator

Is there a way to turn up the fuel on a farmall 560 without changing the head on the pump?such as a fuel adjustment screw? Any help is appreciated.This also has a roosa master pump in case they have different models.




[Log in to Reply]   [No Email]
ejr-IA.

01-21-2006 15:45:02




Report to Moderator
 Re: Farmall 560 Diesel (turn up fuel) in reply to Justin Wiseman, 01-21-2006 11:05:06  
It is hard to explain in a post.Theirs a enternal setting also.You have to use a allen wrench and tighten the enternal leaf spring to get more fuel.To do this you have to take the top of the pump off and remove some linkage ,down in the bottom you will see a round hole,turn the engine over untill you see the head of the allen screw tighten it down.



[Log in to Reply]  [No Email]
Ted in NE

01-21-2006 15:03:57




Report to Moderator
 Re: Farmall 560 Diesel (turn up fuel) in reply to Justin Wiseman, 01-21-2006 11:05:06  
The torque screw is the simplest way to set up the fuel. Is located next to the block, midway on the injection pump. Could have a cap over it, with a seal wire. Takes a 7 sixteenths wrench & small allen wrench. Back out for more fuel.Make sure fuel filters are clean. This should be adequate for an NA engine. Can get more with the internal roller adjustment in pump but will just smoke more unless turboed

[Log in to Reply]  [No Email]
jpl

01-21-2006 13:01:12




Report to Moderator
 Re: Farmall 560 Diesel (turn up fuel) in reply to Justin Wiseman, 01-21-2006 11:05:06  
justin, i live by amanda and think i have a book on the diesel shows where the adjustment screws are. i;ll check and let you know. hows ralph doing or do i have wrong person. jerry in amanda.



[Log in to Reply]  [No Email]
Kevin

01-21-2006 12:02:09




Report to Moderator
 Re: Farmall 560 Diesel (turn up fuel) in reply to Justin Wiseman, 01-21-2006 11:05:06  
You will probly get more help with this in the pulling forum.



[Log in to Reply]  [No Email]
[Options]  [Printer Friendly]  [Posting Help]  [Return to Forum]   [Log in to Reply]

Hop to:


TRACTOR PARTS TRACTOR MANUALS
We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]

Home  |  Forums


Copyright © 1997-2023 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters

Website Accessibility Policy