TRACTOR PARTS Allis Chalmers Case & David Brown Farmall & International Ferguson Ford & New Holland John Deere Massey Ferguson Massey Harris Minneapolis Moline Oliver & Cockshutt Kubota / Yanmar

TRACTOR MANUALS

Allis Chalmers	Case	Farmall IH	Ford 8N,9N,2N	Ford
Ferguson	John Deere	Massey Ferguson	Minn. Moline	Oliver

Farmall & IHC Tractors Discussion Forum

Well, she's done.

Welcome Guest, Log in or Register

Author

Farmall Frank

01-20-2006 10:26:55

Report to Moderator

Spent the last year resurrecting this beast from 50 years of outside living. Replaced almost every seal and gasket everywhere, rebuilt TA, new radiator, POR 15'd both fuel tanks, rebuilt the hydraulic control valves, regulator, and hyd. cylinders, new hyd. lines, replaced clips, bolts, QA pins, etc., lost over the years, all new wiring and gages, rebuilt water pump and distributer parts, main clutch and bearings, paint, and on.

The only things I did not get into were the engine and transmission, fuel pump, and hyd. pump. Thought I had a problem of antifreeze in the oil, but that was a false alarm -- what a relief.

The 400D lives for a future generation!

[Log in to Reply] [No Email]

Kelly C

01-20-2006 19:05:47

Report to Moderator

Re: Well, she's done. in reply to Farmall Frank, 01-20-2006 10:26:55

WOW!!! You done good. I hope I can make my 400 look 1/2 as nice.

[Log in to Reply] [No Email]

Specter

01-20-2006 15:32:09

Report to Moderator

Re: Well, she's done. in reply to Farmall Frank, 01-20-2006 10:26:55

I think I've just been converted! :-)

Specter
Alberta, Canada

[Log in to Reply] [No Email]

Farmer Bob

01-20-2006 13:54:26

Report to Moderator

Re: Well, she's done. in reply to Farmall Frank, 01-20-2006 10:26:55

I can almost hear it purring! Super job. Keep up the good work.

[Log in to Reply] [No Email]

Mcred

01-20-2006 13:49:12

Report to Moderator

Re: Well, she's done. in reply to Farmall Frank, 01-20-2006 10:26:55

Very well done looks nice. We have and use all of our Farmalls around the farm here. We have four gas start diesels around here including a SuperMD, 450D, WD9,650D and alot of others that are gas just, counted a total of 15 some restored and some not any were from a B farmall to a 986. We really enjoy using the diesels thou use the 450D for cutting hay and that is a very nice set up. It is always nice to see them diesel restored rather than junked out.

[Log in to Reply] [No Email]

Allan in NE

01-20-2006 12:52:05

Report to Moderator

Re: Well, she's done. in reply to Farmall Frank, 01-20-2006 10:26:55

Nice, Nice, Nice!!

I want one too!!! :>)

Allan

[Log in to Reply] [No Email]

sammy the RED

01-20-2006 12:47:34

Report to Moderator

Re: Well, she's done. in reply to Farmall Frank, 01-20-2006 10:26:55

WTG ... Nice !

[Log in to Reply] [No Email]

John in Ne.

01-20-2006 12:20:24

Report to Moderator

Re: Well, she's done. in reply to Farmall Frank, 01-20-2006 10:26:55

Nice looking tractor,and nice looking background. I haven't seen green grass for three months,where you at? John.

[Log in to Reply] [No Email]

Farmall Frank

01-20-2006 12:26:39

Report to Moderator

Re: Well, she's done. in reply to John in Ne., 01-20-2006 12:20:24

I'm from good old Kansas, the bananna belt of the midwest, at least lately. That's my dad's barn and land. Matter of fact, I took the picture there because the old girl sat out front of that barn for many, many years. Thought it proper, then and now.

She goes in a nice enclosed barn from here on out.

Thanks.

[Log in to Reply] [No Email]

Brad in WI

01-20-2006 12:15:41

Report to Moderator

Re: Well, she's done. in reply to Farmall Frank, 01-20-2006 10:26:55

Wow that is beautiful Well done. Nice to see the old gas start diesel around. Hope one day to have my MD look half as good as your 400D.
Brad

[Log in to Reply] [No Email]

scotty

01-20-2006 11:49:35

Report to Moderator

Re: Well, she's done. in reply to Farmall Frank, 01-20-2006 10:26:55

Beautiful job Frank, what a beauty!!!

scotty

[Log in to Reply] [No Email]

Tim...Ok

01-20-2006 11:22:42

Report to Moderator

Re: Well, she's done. in reply to Farmall Frank, 01-20-2006 10:26:55

Beautiful..nice job..

Tim

[Log in to Reply] [No Email]

caseyc

01-20-2006 10:36:05

Report to Moderator

Re: Well, she's done. in reply to Farmall Frank, 01-20-2006 10:26:55

that"s really sharp! wish i could find an old 300/350/400/450. they bring pretty good money around my area. good job!

casey in SD

[Log in to Reply] [No Email]

Andrew Z

01-20-2006 12:44:35

Report to Moderator

Re: Well, she's done. in reply to caseyc, 01-20-2006 10:36:05

When there restored to the point you got that 400D that impressive that you repalced all the seals and gaskest. I see so may retorations have leaks and grease still on them. Well Done! Andrew

[Log in to Reply] [No Email]

[Options] [Printer Friendly] [Posting Help] [Return to Forum] [Log in to Reply]

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]

Home | Forums

Copyright © 1997-2023 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters

Website Accessibility Policy