Leaky H

First, I can"t keep the seal for the tranny input shaft from leaking. The driveshaft yoke has a groove wore in it and I can"t seem to place the seal in a different place so I can get it to ride outside of the groove. Question is: has anybody used a speedi-sleeve on this yoke or is it better to try to find a used yoke that doesn"t have so much wear on it?

Second leak is behind the governor, probably where the throttle shaft enters the governor. I haven"t taken the governor off yet. The question is: how difficult is it to replace this seal and, if necessary, can this shaft be speedi-sleeved?

Thanks in advance for all the help.
Larry

The seal on the upper (main) shaft of the transmission just get splashed with oil, so I was also suprised when after changing the seal I still had a leak. Turns out that the gasket behind the bearing housing unit was bad. I changed it (and the bearing as long as I was there) no more problem.

The leak on the governor is probably indeed the control leaver shaft. Mine was badly grooved. This shaft takes only minor wear and tear (it dosen"t spin continously like the engine shafts) so I patched mine with JB Weld and replaced the seal (easy job) and haven"t had a leak in four years.