Welcome! Please use the navigational links to explore our website.
PartsASAP LogoCompany Logo Auction Link (800) 853-2651

Shop Now

   Allis Chalmers Case Farmall IH Ford 8N,9N,2N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver

Farmall & IHC Tractors Discussion Forum
:

pump update

Welcome Guest, Log in or Register
Author 
fenton

12-02-2005 11:52:07




Report to Moderator

Well....got the rebuild kit from IH. Took the pump to them and they looked at it. They thought a new o-ring seal will work on the shaft as the wear was not too bad. They said to smooth it out a bit with emory cloth. Got it back together and so far so good. The sleeve on the shaft fix was not to their liking and said the clearence is too tight between the shaft and the hole it goes in and machining is very costly??? Their words. Now...the only replacement pump they show is around $600....YIKES!!! I am sure some where there are cheaper ways if the pump fails again. I'm not using it much, so I hope it holds.

[Log in to Reply]   [No Email]
gene bender

12-02-2005 17:06:21




Report to Moderator
 Re: pump update in reply to fenton, 12-02-2005 11:52:07  
I guess i know more about these pumps that they do and must have had much more experience also. Just put the pump together then put the speedy sleev on as the ones i have used do not require any machining.



[Log in to Reply]  [No Email]
El Toro

12-02-2005 13:19:24




Report to Moderator
 Re: pump update in reply to fenton, 12-02-2005 11:52:07  
If it leaks, install a speedi-sleeve from Chicago- Rawhide. They work on a crankshaft hub & they'll work on that pump shaft. Hal



[Log in to Reply]  [No Email]
[Options]  [Printer Friendly]  [Posting Help]  [Return to Forum]   [Log in to Reply]

Hop to:


TRACTOR PARTS TRACTOR MANUALS
We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]

Home  |  Forums


Copyright © 1997-2023 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters

Website Accessibility Policy