TRACTOR PARTS Allis Chalmers Case & David Brown Farmall & International Ferguson Ford & New Holland John Deere Massey Ferguson Massey Harris Minneapolis Moline Oliver & Cockshutt Kubota / Yanmar

TRACTOR MANUALS

Allis Chalmers	Case	Farmall IH	Ford 8N,9N,2N	Ford
Ferguson	John Deere	Massey Ferguson	Minn. Moline	Oliver

Farmall & IHC Tractors Discussion Forum

350U will not run

Welcome Guest, Log in or Register

Author

Mark and Anik

09-19-2005 17:39:45

Report to Moderator

Last winter on the last driveway snowplow of the season, my International 350U gave a massive backfire and quit working. It is time for me to take a look at it for the next long winter- but where to start. It will turn over with difficulty but seems to bind up or something. I had the pan off right off the bat and there are no parts seeming wrong. My experience is more with newer automobiles and thought - timing chain - but I know nothing about this engine. Any ideas will be greatly appreciated. Thanks.

[Log in to Reply] [No Email]

El Toro

09-19-2005 18:45:57

Report to Moderator

Re: 350U will not run in reply to Mark and Anik, 09-19-2005 17:39:45

I would bring No1 piston up the compression stroke
to TDC. You need to remove No1 plug near the radiator and feel for compression against your thumb as someone handcranks the engine. Stop cranking when piston is at TDC and the timing mark is aligned with the pointer.

Check the rotor to see where it is pointing on the cap. It should be at No1 plug wire in the cap. If this appears ok you should check the point gap and clean the points. Gap is probably .020". After this, check for fire at your sparkplugs when cranking the engine with the ignition switch on and using the starter. No fire I would replace the points and condenser and try again & check for fire. I would drain the old gas and put in fresh gas too. Still no fire I would buy a new coil. Hal PS: Check for battery voltage at your coil with ignition switch on with a lite or volt meter.

[Log in to Reply] [No Email]

Mark and Anik

09-21-2005 20:36:24

Report to Moderator

Re: 350U will not run in reply to El Toro, 09-19-2005 18:45:57

Ignition parts are all new. I pulled off the hydraulic pump and peered in. No teeth on the timing gear. I guess I know what is wrong now. Anybody know where I can get a set of gears for this tractor?

[Log in to Reply] [No Email]

El Toro

09-22-2005 03:54:58

Report to Moderator

Re: 350U will not run in reply to Mark and Anik, 09-21-2005 20:36:24

Here's a website for salvageyards in your area.
It contains 16 pages for all over the U.S. Hal

PS: Try Carter & Gruenewald at 1-800-283-2122 and your local Case/IH dealer may have them and ask for a copy from their service manual on retiming those gears correctly.

http://www.epartdirect.com/index.php?t=fc&s=s

[Log in to Reply] [No Email]

[Options] [Printer Friendly] [Posting Help] [Return to Forum] [Log in to Reply]

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]

Home | Forums

Copyright © 1997-2023 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters

Website Accessibility Policy