Copyright © 1997-2023 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
: <a href= http://us.f1.yahoofs.com/bc/641a983d_m4187e210/bc/F-20N/Farmall+F-20N+May+19+2003+035.jpg?BCHHgLDByQ_rpPPv>Link</a> After getting it loosened up, the piston out, and honing it looks like this. You can still see some corrosion, and you can see a couple small divots in the sleeve wall. <a href= http://us.f1.yahoofs.com/bc/641a983d_m4187e210/bc/F-20N/Sleeves+005.jpg?BCHHgLDBAm5vaMKX>Link</a> http://us.f1.yahoofs.com/bc/641a983d_m4187e210/bc/F-20N/Sleeves+004.jpg?BCHHgLDB7SRIV.zo Is this sleeve unusable? If so, would I then want to replace all 4? Any other comments are welcome as well. I){kind=link}