TRACTOR PARTS Allis Chalmers Case & David Brown Farmall & International Ferguson Ford & New Holland John Deere Massey Ferguson Massey Harris Minneapolis Moline Oliver & Cockshutt Kubota / Yanmar

TRACTOR MANUALS

Allis Chalmers	Case	Farmall IH	Ford 8N,9N,2N	Ford
Ferguson	John Deere	Massey Ferguson	Minn. Moline	Oliver

Farmall & IHC Tractors Discussion Forum

H steering bolster

Welcome Guest, Log in or Register

Author

Mort

04-14-2005 16:55:41

Report to Moderator

Hi, I need to replace the baering and bushing on a H. how do i remove the bearing and bushing they seem to be part of the shaft. this is not what the book shows. Can some one explain how to do the removal. Thanks craig

[Log in to Reply] [No Email]

mort

04-15-2005 10:52:03

Report to Moderator

Re: H steering bolster in reply to Mort, 04-14-2005 16:55:41

Thanks Glenn , I'll try that to day mort

[Log in to Reply] [No Email]

Glen E.

04-14-2005 19:25:10

Report to Moderator

Re: H steering bolster in reply to Mort, 04-14-2005 16:55:41

If it is like my M.....
I unbolted the lower half of the bolster while I had the tractor jacked up. I then took the nut off of the top of the steering gear, and the whole upper bolster shaft slid out the bottom. The thrust bearing, felt washer and felt washer cover slid off pretty easy. The big lower bushing (in the bolster housing) came out fairly easy with a hammer and dull chisel. The new one was a bear to put back in though. The smaller bushing in the top of the housing about ate my lunch. I was finally able to roll it out with a good sharp chisel and a hammer. The seal below it came out pretty easy. You will need some one with small hands or figure out a tool to put the seal back in though. A little persuasion with a hammer and a piece of oak was all I needed to get the top bushing back in.

Hope this helps.

[Log in to Reply] [No Email]

[Options] [Printer Friendly] [Posting Help] [Return to Forum] [Log in to Reply]

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]

Home | Forums

Copyright © 1997-2023 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters

Website Accessibility Policy