Welcome! Please use the navigational links to explore our website.
PartsASAP LogoCompany Logo Auction Link (800) 853-2651

Shop Now

   Allis Chalmers Case Farmall IH Ford 8N,9N,2N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver

Farmall & IHC Tractors Discussion Forum
:

826 IH seal torque

Welcome Guest, Log in or Register
Author 
Todd in Sask.

03-16-2005 20:07:14




Report to Moderator

My front & rear engine seals are leaking bad. Do I need to split the tractor to do the rear seal?? Also when I have been putting a bigger load on the tractor it when seem like the clutch is slipping when the torque is not in. I have been pushing snow this winter and several times the tractor would act like this was happening. I could look out the cab window and the tires were not turning/push the lever up and bang away it would go again. Is it oil leaking on the clutch or is the torque going?? I'm not familiar with this tractor yet so any advice/help would be great.. Mainly use this tractor for running haybine & a round baler. It's a diesel if that matters.

Thanks,
Todd

[Log in to Reply]   [No Email]
K.B.-826

03-16-2005 21:37:39




Report to Moderator
 Re: 826 IH seal torque in reply to Todd in Sask., 03-16-2005 20:07:14  
Yes, you need to split the tractor to replace the rear main seal. It also takes a special tool to set the seal at the correct depth. The tool can set the seal in three different 1/16 of an inch increments, so it wears on a different place of the crankshaft each time you replace it, so pay attention to where it is now. It definetly sounds like the TA is out. Sounds like a good time to do a complete TA job.

[Log in to Reply]  [No Email]
[Options]  [Printer Friendly]  [Posting Help]  [Return to Forum]   [Log in to Reply]

Hop to:


TRACTOR PARTS TRACTOR MANUALS
We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]

Home  |  Forums


Copyright © 1997-2023 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters

Website Accessibility Policy