Welcome! Please use the navigational links to explore our website.
PartsASAP LogoCompany Logo Auction Link (800) 853-2651

Shop Now

   Allis Chalmers Case Farmall IH Ford 8N,9N,2N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver

Farmall & IHC Tractors Discussion Forum
:

case/IH 695 forward/reverse clutches

Welcome Guest, Log in or Register
Author 
corey c.

02-17-2005 14:27:52




Report to Moderator

got a 695 with mfd that slips in forward, more so in reverse. Wont pull itself in reverse. Split tractor and took forward/reverse unit out and took it apart. Found that the screws that hold the pistons together had backed completly out. Installed new pistons/plates and disc's. Installed new seal rings in the pistons and clutch shaft. When i blow air into the oil inlet of the carrier..it doesnt hold good pressure. The clutches seem to lock up when i put air to it and move the spool. Just sounds like it leaks to much. The ring lands on the carrier and shaft seem fair. I have taken the unit apart again to make sure i didnt break the 3 seal rings on the clutch shaft,,,the were ok. Is this leakage normal? Does the aqpprox. 320 psi seal the unit good enough?

[Log in to Reply]   [No Email]
RickB

02-17-2005 15:33:23




Report to Moderator
 Re: case/IH 695 forward/reverse clutches in reply to corey c., 02-17-2005 14:27:52  
Nothing wrong with air testing clutchpacks, but you have to learn to expect/accept air leakage. Air is after all, much thinner than oil. If you are moving the piston and locking up the clutch, you are probably OK. I don't work on many CIH, but I would expect 320PSI to lock it up well.



[Log in to Reply]  [No Email]
[Options]  [Printer Friendly]  [Posting Help]  [Return to Forum]   [Log in to Reply]

Hop to:


TRACTOR PARTS TRACTOR MANUALS
We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]

Home  |  Forums


Copyright © 1997-2023 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters

Website Accessibility Policy