TRACTOR PARTS Allis Chalmers Case & David Brown Farmall & International Ferguson Ford & New Holland John Deere Massey Ferguson Massey Harris Minneapolis Moline Oliver & Cockshutt Kubota / Yanmar

TRACTOR MANUALS

Allis Chalmers	Case	Farmall IH	Ford 8N,9N,2N	Ford
Ferguson	John Deere	Massey Ferguson	Minn. Moline	Oliver

Farmall & IHC Tractors Discussion Forum

H/ SH block bore ?

Welcome Guest, Log in or Register

Author

Andy in Ohio

01-08-2005 20:10:14

Report to Moderator

Is the bore in the block of an H the same as a SH before the sleeves are installed? Or will a SH kit fit in an H block? The H does have hi compression pistons if that makes a difference. Thanks, Andy

[Log in to Reply] [No Email]

ChadS

01-10-2005 08:17:37

Report to Moderator

Re: H/ SH block bore ? in reply to Andy in Ohio, 01-08-2005 20:10:14

H is 3-3/8 Super H is 3-7/16, and had an overbore kit for 3.5 bore for the H-Super H series engine. the sleeves from the H up to the 3.5 overbore will fit the older H-SH block style. 3-5/8,,, pull out the sleeves, and run the C-175 head gasket on the H block, Hope this helps,, ChadS

[Log in to Reply] [No Email]

junkyard dog

01-09-2005 16:17:50

Report to Moderator

Re: H/ SH block bore ? in reply to Andy in Ohio, 01-08-2005 20:10:14

SH&H are not the same bore. H is 3 9/16 bare bore don't know whatSH is BUT SH over bore or 300 pistons will slide right in w/o sleeves

[Log in to Reply] [No Email]

DWV

01-09-2005 06:18:47

Report to Moderator

Re: H/ SH block bore ? in reply to Andy in Ohio, 01-08-2005 20:10:14

Around 1/8 inch differance in diameter of block
bores.

[Log in to Reply] [No Email]

[Options] [Printer Friendly] [Posting Help] [Return to Forum] [Log in to Reply]

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]

Home | Forums

Copyright © 1997-2023 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters

Website Accessibility Policy