TRACTOR PARTS Allis Chalmers Case & David Brown Farmall & International Ferguson Ford & New Holland John Deere Massey Ferguson Massey Harris Minneapolis Moline Oliver & Cockshutt Kubota / Yanmar

TRACTOR MANUALS

Allis Chalmers	Case	Farmall IH	Ford 8N,9N,2N	Ford
Ferguson	John Deere	Massey Ferguson	Minn. Moline	Oliver

Farmall & IHC Tractors Discussion Forum

land plow for a farmall A no hydraulics

Welcome Guest, Log in or Register

Author

mike bowker

11-24-2004 19:33:05

Report to Moderator

I father-in-law is looking for a land plow for a farmall A no hydraulics. We live in New England. We think his last one was a JD #52, which used a rope to trip the plow up or down to the ground. Any body have something like this, in the NE at a reasonable price?

Thank you for your help
Mike

[Log in to Reply] [No Email]

El Toro

11-25-2004 08:31:05

Report to Moderator

Re: land plow for a farmall A no hydraulics in reply to mike bowker, 11-24-2004 19:33:05

Hi Mike, You may find a moldboard plow to fit the Farmall A at your local farm equipment dealer.
I had an A with a 16-inch plow. You had to remove
the drawbar in order to install the plow and it wasn't that hard to raise and lower the plow.

That JD52 sounds like a trailing type
plow that we used when I was on the farm. Only we used 2-bottom IH plows. These plows may more readily available since farmer's are using bigger tractors now that can handle 4-bottom or even 5-bottom plows. They do a lot of no-till in my area
and some are using chisel plows.

I'm not sure the A would pull a 2-bottom plow, but if it wouldn't you could remove
one of the moldboard's and make it a single furrow plow. It would just take a little longer.
They use no-till around here to keep the top soil
from washing away during heavy rains. They strip crop a lot too on hilly slopes.

Send an email to Lancaster Farming Journal to request a courtesy copy of their paper.
It has a lot of farm equipment advertised in it.
This is their email address farming@lancasterfarming.com, if you have a problem call 717-626-1164. Good Luck, Hal

[Log in to Reply] [No Email]

wanabfarmer

11-26-2004 19:59:11

Report to Moderator

Re: land plow for a farmall A no hydraulics in reply to El Toro, 11-25-2004 08:31:05

go to photo adds this site you will find both trailer& bolt on type hope this helps good plowing

[Log in to Reply] [No Email]

[Options] [Printer Friendly] [Posting Help] [Return to Forum] [Log in to Reply]

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]

Home | Forums

Copyright © 1997-2023 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters

Website Accessibility Policy