TRACTOR PARTS Allis Chalmers Case & David Brown Farmall & International Ferguson Ford & New Holland John Deere Massey Ferguson Massey Harris Minneapolis Moline Oliver & Cockshutt Kubota / Yanmar

TRACTOR MANUALS

Allis Chalmers	Case	Farmall IH	Ford 8N,9N,2N	Ford
Ferguson	John Deere	Massey Ferguson	Minn. Moline	Oliver

Farmall & IHC Tractors Discussion Forum

Farmall H head bolt torque sequence

Welcome Guest, Log in or Register

Author

SCOTT IN MO

08-10-2004 15:45:02

Report to Moderator

Getting ready to put the head on my H and was wanting to know what the torque sequence is for the bolts . I know that the head torques at 70 foot pounds. and also is it necessary to seal the studs that go through in the block.Thanks for any help. also is there any need to spray the head gasket with a sealer,thanks again.

[Log in to Reply] [No Email]

riverbend

08-10-2004 17:45:53

Report to Moderator

Re: Farmall H head bolt torque sequence in reply to SCOTT IN MO, 08-10-2004 15:45:02

Start in the middle and spiral out towards the ends. Follow the torque sequence that Jon gave. Re-torque after the engine comes up to operating temperature and cools off. I did not use a sealer and have a tiny oil leak under the spark plugs. When it is due for a valve adjustment, I'll re-re-torque the head, it will be fine.

Greg

[Log in to Reply] [No Email]

Mag Man

08-10-2004 17:25:30

Report to Moderator

Re: Farmall H head bolt torque sequence in reply to SCOTT IN MO, 08-10-2004 15:45:02

#1 The torque I start out at about 35 FPs My self then go to 55 then 65 to 70 I think there is a sequence in the book but I just stager them. You dont need to seal the bolts. Some say to use no sealer I my self use Spray gasket adheasive I buy from Napa. JON

[Log in to Reply] [No Email]

[Options] [Printer Friendly] [Posting Help] [Return to Forum] [Log in to Reply]

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]

Home | Forums

Copyright © 1997-2023 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters

Website Accessibility Policy