Welcome! Please use the navigational links to explore our website.
PartsASAP LogoCompany Logo Auction Link (800) 853-2651

Shop Now

   Allis Chalmers Case Farmall IH Ford 8N,9N,2N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver

Farmall & IHC Tractors Discussion Forum
:

Farmall H head stud bolts

Welcome Guest, Log in or Register
Author 
SCOTT IN MO

08-01-2004 20:04:11




Report to Moderator

Just getting ready to put my head bolts in my block and the ih book shows there 11 short bolts and 5 long bolts can anyone tell me the placement of the long bolts. I do know that some bolt holes go all the way through the block >THANKS




[Log in to Reply]   [No Email]
Wayne Swenson

08-01-2004 21:08:07




Report to Moderator
 Re: Farmall H head stud bolts in reply to SCOTT IN MO, 08-01-2004 20:04:11  
3 of them are in the center of the head and have heavy washers under them. 2 are on the left (carb side) and are used to hold the throttle lever pivot.
Silicone the threads on all bolts for good measure and check with a ruler to get them all installed to the correct height. Set the head in place without the gasket for a trial run on correct length. You want the stud to extend through the nut about 1 thread so it has full contact and holding power.
Install the gasket.
Torque the nuts in sequence and about 1/3 of full value at a time. Then go over them all a 4th time around for good measure.

[Log in to Reply]  [No Email]
[Options]  [Printer Friendly]  [Posting Help]  [Return to Forum]   [Log in to Reply]

Hop to:


TRACTOR PARTS TRACTOR MANUALS
We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]

Home  |  Forums


Copyright © 1997-2023 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters

Website Accessibility Policy