Welcome! Please use the navigational links to explore our website.
PartsASAP LogoCompany Logo Auction Link (800) 853-2651

Shop Now

   Allis Chalmers Case Farmall IH Ford 8N,9N,2N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver

Farmall & IHC Tractors Discussion Forum
:

Farmall H

Welcome Guest, Log in or Register
Author 
Farm w/Junk

04-04-2004 18:56:35




Report to Moderator

Hi I picked up a new toy today. Its a farmall H but the tag is missing so year is unknown. It is unique from my 1946 because the deck plate where seat attaches has a groove where the seat bolts on. Did they put these on certain years? Also it is electric start and the starter button is in the rear gas tank support not on the steering post. What year is this tractor? Will put a pic on tomorrow of it. Thanks
Matt

[Log in to Reply]   [No Email]
Paul in Mich

04-05-2004 18:15:11




Report to Moderator
 Re: Farmall H in reply to Farm w/Junk, 04-04-2004 18:56:35  
Farm w/junk, The slot question has been answered, but not the starter question. The early models had the starter button switch mounted on the rear gas tank support as you described, however, there was also a 1/4" dia. pin that went through the steering post to the starter button so that you could push it with your foot. Beginning with the 1945's the starter button was relocated to the clutch pedal side of the steering post just below the light bar. As to the choke rod not having a place to mount, there was a square plate mounted to the steering post which accomodated the choke rod as well as the pulley control rod. The shutter control was also mounted there on models which had radiator shutters. Some models also had the ignition switch mounted on the same plate, although not all models, as some had the ignition switch mounted on the belly pump control rod bracket. The 1939 models had a mechanical ignition kill switch to the magneto which resembled a choke cable rather than the elictrical kill switch seen on most magneto ignitions. Since your tractor is a 1939, you have many features or the lack thereof exclusive of the newer models. In fact, some came with no starter, but hand crank. In that case, no choke rod went back to the operators platform, as they were choked while cranking. Nearly everything taken for granted on the later models were options in 1939 such as electric start, lights, belt pulley, pto, belly pump power lift, which if added later could be minus a few mounting parts. One thing you can do as time goes on is to attend a few tractor shows, and look for a 39 and see how things are arranged. You can also talk to owners as you come in contact with them and glean a lot of knowledge which they are usually eager to share.

[Log in to Reply]  [No Email]
Scott

04-05-2004 09:18:56




Report to Moderator
 Re: Farmall H in reply to Farm w/Junk, 04-04-2004 18:56:35  
Question since we are on this train of thought. My 41 has starter on gas tank support also, when did they move it to the steering support. Also my choke rod just flops around, can not find a empty hole or bracket where it might go, any ideas?



[Log in to Reply]  [No Email]
rustyfarmall

04-05-2004 04:44:44




Report to Moderator
 Re: Farmall H in reply to Farm w/Junk, 04-04-2004 18:56:35  
Look for the casting codes, located on just about every part of your tractor, if the code ends in the letter I, it is a 39.



[Log in to Reply]  [No Email]
rustyfarmall

04-05-2004 04:48:06




Report to Moderator
 Re: Re: Farmall H in reply to rustyfarmall, 04-05-2004 04:44:44  
It is also possible that there never was a tag, I think the serial number was stamped into the top of the frame rail on the early models, I don't remember which side.



[Log in to Reply]  [No Email]
James Williams

04-04-2004 19:07:26




Report to Moderator
 Re: Farmall H in reply to Farm w/Junk, 04-04-2004 18:56:35  
Good find,Sounds like a 1939



[Log in to Reply]  [No Email]
Jeff_MI

04-04-2004 19:05:57




Report to Moderator
 Re: Farmall H in reply to Farm w/Junk, 04-04-2004 18:56:35  
If it's a groove from the back middle of the deck and it goes between the seat mounts, it would be a 1939; the 39's were the only ones that had them. What about the engine serial number, located just below the front spark plug on a flat surface?



[Log in to Reply]  [No Email]
[Options]  [Printer Friendly]  [Posting Help]  [Return to Forum]   [Log in to Reply]

Hop to:


TRACTOR PARTS TRACTOR MANUALS
We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]

Home  |  Forums


Copyright © 1997-2023 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters

Website Accessibility Policy