Welcome! Please use the navigational links to explore our website.
PartsASAP LogoCompany Logo Auction Link (800) 853-2651

Shop Now

   Allis Chalmers Case Farmall IH Ford 8N,9N,2N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver

Farmall & IHC Tractors Discussion Forum
:

H Clutch Question

Welcome Guest, Log in or Register
Author 
RayA

01-02-2004 17:05:52




Report to Moderator

Hello all, I just took off the inspection plate below the clutch houseing and low and behold the fingers arent even. From an earlier post I was told to adjust them 2-5/32th, Is that distance from the flywheel face or from the throw out bearing and also is that 2 inches and 5/32, or 2 to 5/32 of an inch. I have never adjusted a clutch before so sorry if these questions are kinda corny. Thanks in advance and thanks to Mike in Ontario for earlier post. Ray in OK

[Log in to Reply]   [No Email]
Wayne Swenson

01-02-2004 21:28:46




Report to Moderator
 Re: H Clutch Question in reply to RayA, 01-02-2004 17:05:52  
That should be the distance from the pressure plate face to the fingers. The distance is 2 & 5/16" (2.3125"). All fingers should be even so the throwout bearing will touch all of them at the same time.



[Log in to Reply]  [No Email]
RayA

01-03-2004 10:01:55




Report to Moderator
 Re: Re: H Clutch Question in reply to Wayne Swenson, 01-02-2004 21:28:46  
Thanks for the reply...going to go check those out today....wooohooooo . RayA



[Log in to Reply]  [No Email]
[Options]  [Printer Friendly]  [Posting Help]  [Return to Forum]   [Log in to Reply]

Hop to:


TRACTOR PARTS TRACTOR MANUALS
We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]

Home  |  Forums


Copyright © 1997-2023 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters

Website Accessibility Policy