TRACTOR PARTS Allis Chalmers Case & David Brown Farmall & International Ferguson Ford & New Holland John Deere Massey Ferguson Massey Harris Minneapolis Moline Oliver & Cockshutt Kubota / Yanmar

TRACTOR MANUALS

Allis Chalmers	Case	Farmall IH	Ford 8N,9N,2N	Ford
Ferguson	John Deere	Massey Ferguson	Minn. Moline	Oliver

Farmall & IHC Tractors Discussion Forum

SUPER MTA

Welcome Guest, Log in or Register

Author

PAUL

11-10-2003 18:21:06

Report to Moderator

IM LOOKING AT A SUPER MTA WITH A WIDE FRT NO 3 POINT SERIAL# 72291 IN GOOD CONDITION ONLY PROBLEM IS THE TA CHATTERS SOUNDS LIKE A LOOSE FLYWHEEL BOLT BUT IS WORKING HOW MUCH HASSLE TO REPAIR AND WHAT WOULD BE A FAIR PRICE?? PAUL

[Log in to Reply] [No Email]

Dan

11-10-2003 22:47:46

Report to Moderator

Re: SUPER MTA in reply to PAUL , 11-10-2003 18:21:06

I suspect if the TA rattles it has a problem in the ta clutch. Does it slip in high or low? It could just need adjustment also. There is a quite complicated asjustment procedure for the ta and main clutch. If ta needs work you have to split the tractor twice, remove center section and disasemble it. Not a bad job if you have a hoist or loader and are not afraid of it. Also if you have service manuel and parts book. As far as worth of tractor, would depend upon the rest of the tractor, tires, metal, how well engine runs, live hydraulics, pto function.

[Log in to Reply] [No Email]

hal

11-11-2003 02:34:42

Report to Moderator

Re: Re: SUPER MTA in reply to Dan, 11-10-2003 22:47:46

I would think an average mta would be worth any where from $1000.00 to $2250.00. alot of it depends on tires, paint, sheet metal, and overall condition. I was at a sale here in IN. last saturday and a mta that supposably had the engine and ta rebuilt brought $4500.00. It might have been worth about $2000.00. it needed paint and had a major hydralic leak and the hydralics did not work and the pump was howling. it can't be good on it to run without oil in the pump. but everthing at the sale brought way over what it was worth. junk gravity flow wagon were going for at least $450.00 good ones were bringing $1000.00 - $1800.00 no bargins there that day.

[Log in to Reply] [No Email]

[Options] [Printer Friendly] [Posting Help] [Return to Forum] [Log in to Reply]

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]

Home | Forums

Copyright © 1997-2023 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters

Website Accessibility Policy