TRACTOR PARTS Allis Chalmers Case & David Brown Farmall & International Ferguson Ford & New Holland John Deere Massey Ferguson Massey Harris Minneapolis Moline Oliver & Cockshutt Kubota / Yanmar

TRACTOR MANUALS

Allis Chalmers	Case	Farmall IH	Ford 8N,9N,2N	Ford
Ferguson	John Deere	Massey Ferguson	Minn. Moline	Oliver

Farmall & IHC Tractors Discussion Forum

smokin (h) ! burnin some oil

Welcome Guest, Log in or Register

Author

Jonathan Mirgon

10-25-2003 07:42:56

Report to Moderator

loose valve guides allowing oil to go down the valve stem and burn the oil, or bad rings ? Does anyone know a good way to determine where the oil is getting into the combustion chamber. I dont really want to re-ring the pistons if the valve guides are the problem. I considered doing a compression test but I dont think that would indicate the condition of the oil control ring. It is not over full on oil. Any help appreciated. Thanks ,
Jonathan Mirgon
Mirgon@ohiohills.com

[Log in to Reply] [No Email]

Allan

10-25-2003 07:56:40

Report to Moderator

Re: smokin (h) ! burnin some oil in reply to Jonathan Mirgon, 10-25-2003 07:42:56

John,

Take 'er out on the road and wind her up in road gear. Then just reach down and move the throttle down to an idle leaving it in gear letting the ground speed pull it down.

Note if the smoke gets worse on deacceleration. If it does, then look at the rings.

If on the other hand, it smokes excessevely after sitting all night and then clears up somewhat after running awhile, this points to the guides.

Hope this helps,

Allan

[Log in to Reply] [No Email]

[Options] [Printer Friendly] [Posting Help] [Return to Forum] [Log in to Reply]

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]

Home | Forums

Copyright © 1997-2023 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters

Website Accessibility Policy