3 Point for M

It came out excellent, and I have only one change I would make if I did it again (nobody else would even notice it, just me).

By designing it to make use of the original drawbar, etc... it should bolt right on to my 560 if I ever want to switch it around.

I can take pictures this weekend and e-mail next week if you would like to see it. I'll be baling the next few days so no time till it rains or I am done.....

Thanks!

I used 3/8" steel for most of the fabrication, except where the cylinder attach, there I used 1/2". The 3 point arms are Cat. I arms from the farm store. I cut a third one in 1/2 and used each end to make the top link arms.

I got some excellent adjustable turnbuckles for the arms at Olton Welding (http://www.oltonwelding.com) for about $15 each I think it was. They have lots of other useful parts too.

The cylinders were a pair I had, 2" x 6", they can lift more than the front weight of the tractor can handle as I can lift it of the ground if I'm not careful!