Welcome! Please use the navigational links to explore our website.
PartsASAP LogoCompany Logo Auction Link (800) 853-2651

Shop Now

   Allis Chalmers Case Farmall IH Ford 8N,9N,2N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver

Discussion Forum
:

International 300 utility question

Welcome Guest, Log in or Register
Author 
Tim

06-18-2003 14:32:21




Report to Moderator

I'm splitting the tractor and the last thing left is the bolts holding the engine to the clutch housing.My question is;Is there bolts that go through the housing,or can i get them all from outside?




[Log in to Reply]   [No Email]
Aces

06-18-2003 17:15:59




Report to Moderator
 Re: International 300 utility question in reply to Tim, 06-18-2003 14:32:21  
Should be 3 on each side from the front and 2 from the back into the back of the block under the tank none inside



[Log in to Reply]  [No Email]
Ernie Bob

06-18-2003 22:58:02




Report to Moderator
 Re: Re: International 300 utility question in reply to Aces, 06-18-2003 17:15:59  
Tim,

You didn't say if you were going to seperate the TA from the Trans/Rearend. There is one bolt that you have to remove the plate on the bottom-rear of the TA housing that goes into the Trans/Rearend and is not seen until you remove the plate. I ruined a TA housing the hard way a few years back. Feel free to e-mail me if you have any questions, I've split mine quite a few times.

Good luck!
Ernie Bob

[Log in to Reply]  [No Email]
[Options]  [Printer Friendly]  [Posting Help]  [Return to Forum]   [Log in to Reply]

Hop to:


TRACTOR PARTS TRACTOR MANUALS
We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]

Home  |  Forums


Copyright © 1997-2023 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters

Website Accessibility Policy