TRACTOR PARTS Allis Chalmers Case & David Brown Farmall & International Ferguson Ford & New Holland John Deere Massey Ferguson Massey Harris Minneapolis Moline Oliver & Cockshutt Kubota / Yanmar

TRACTOR MANUALS

Allis Chalmers	Case	Farmall IH	Ford 8N,9N,2N	Ford
Ferguson	John Deere	Massey Ferguson	Minn. Moline	Oliver

Discussion Forum

CAT 927 20a flywheel clutch question

Welcome Guest, Log in or Register

Author

GISAKLYNE

07-15-2002 11:36:07

Report to Moderator

977 20A SN-1499

Is it possiable to change the rear seal in the oil type flywheel clutch on a 977 20A/D6 with out pulling and taking the clutch apart?

We took the U-Joint and clutch brake off thinking that the piece of the drive saft in the clutch would then slide out giving access to the to the seal. (wrong it would not-to long to clear the trans.). This part of the drive shaft apears to be made in two pieces as it has to different sizes diameters and has a hole in it. But could not figure out how to get it to come apart.

In review of the service manual it apears the rear bearing case may be removeable without pulling the whole clutch. Is It and will there be room to get clear of the tractor?0

Any suggestions? Thanks:

gisaklyne@peoplepc.com

[Log in to Reply] [No Email]

[Options] [Printer Friendly] [Posting Help] [Return to Forum] [Log in to Reply]

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]

Home | Forums

Copyright © 1997-2023 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters

Website Accessibility Policy