I understand the damper doors, etc. That part works, tho in 2010 it very, very likely is not to code in a dwelling. Not much at all is to code any more because there are so many reams of code..... Legal issues aside, I understand & it can work fine.
Your problem is an 8 inch furnace output implies it needs an 8 inch chimney.
You can't really reduce that down to 6 inch and expect it to work.
The extra 2 inches of smoke will try real hard to get around the dampner, etc. of your stove, and there you might actually be doing something deadly. Throttling backa chimney is not a good idea.
I don't think it is wise to throttle down the chimney to a 6 inch, when the furnace has an 8 inch output. I think that will give you major problems.
I'm only a simple dirt farmer, don't know much on heating & heating code, so just my opinion. :) Hope you figure out something to make it work properly.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Rescue of a Fordson F - by Anthony West. Introduction I live in the UK and have for many years restored Fordson tractors (in the main model N's). I have also restored and shown model F's, E 27N's, Field Marshall Series 2, David Brown Cropmasters and the old rey Fergeson T 20. At one time I had seven restored examples which were shown and used in ploughing matches. As most restorers, I have a number of war stories I can relate on a range of topics that may help other like minded and interested people. Perhaps my first p
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.