Posted by NW Ohio Tim on January 27, 2010 at 07:57:49 from (76.76.36.32):
In Reply to: Measurement Needed posted by NW Ohio Tim on January 26, 2010 at 20:43:14:
Armand Tatro said: One more thought: A inch or two too long would be better than too short when a PTO shaft is used.
You hit the nail on the head Armand. I just picked up an Arps snowblower over the weekend and the PTO was too long with my short set of adaptors. Time to get these ready in case it keeps snowing.
I dropped them off at the local welding shop this morning. He said as long as the sockets were welded all the way around it should be OK. He said if I was pulling a chisel plow with a 200 hp tractor, he'd worry about it..... but 35 hp would be OK. He also said if it looked like it needed beefed up when he was done, he'd reinforce it with a strap around the outside.
Thanks for the help guys.
Tim K in NW Ohio ~ Torn between wanting to play with the new snow blower & not wanting anymore snow.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The 8N and the Fox - by Zane Sherman. Dec. 13 1998, Renfroe, Alabama. Last niht I dreamed about the day that I plowed the field of about 10 acres over on what Jimmy and Dandy called the Ledbetter field. I was driving the 1948 8N Ford tractor that Jimmy bought in 48 new This was prebably in about 1951 and maybe even befor the house was built. This would have made me to be about16 years old and I drove the tractor for nothing and would have paid to drive it if I had had any money which I didn't, but neit
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.