Posted by Red1 on July 25, 2009 at 13:38:13 from (4.244.63.83):
In Reply to: Welding sheet metal? posted by 550Doug on July 25, 2009 at 12:54:18:
Take some .060 or .125 material (metal) and cut it to fit tight over the crack, clamp it up real good after cleaning what's under and the patch.
Find some 3/32 6010, turn up the amps so that you can strike a good arc and keep the gap short to keep the volts down..this is the important part,
put the heat on the patch edge and allow that material to weld to the parent material...your mower deck. Keep a small angle...40 degrees or less from perpendicular to the deck
..don't try to fill the butt up in one pass, let the rod buildup over the edge of the patch to the deck. And let it cool down to a point where you can touch it....use an airhose if you've got one...the idea is to get enough weld buildup so you can take a pass over it without stopping...
Used to weld old boilers up that were leaking....patched many a rusted up wall with hardly anything behind it.....practice a little before you try it on the deck.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Rescue of a Fordson F - by Anthony West. Introduction I live in the UK and have for many years restored Fordson tractors (in the main model N's). I have also restored and shown model F's, E 27N's, Field Marshall Series 2, David Brown Cropmasters and the old rey Fergeson T 20. At one time I had seven restored examples which were shown and used in ploughing matches. As most restorers, I have a number of war stories I can relate on a range of topics that may help other like minded and interested people. Perhaps my first p
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.