Posted by Paul from MI on July 19, 2009 at 18:53:03 from (74.204.9.240):
In Reply to: axle seals on 45 A posted by wayne ruder on July 19, 2009 at 16:24:05:
If you are leaking oil at the ends of the axle housing, the seal that's causing the problem is located behind the bull gear in the axle housing. The felt at the end of the axle only keeps dirt out the bearing, not seal in oil. The entire cover can be easily removed from the axle housing, but it's heavy. You will need a way to support it. Removing the axles to get at the seal is pretty straightforward. Remove the wheels, then loosen the axle nuts and use a wedge between the axles to push the axle out of the bull gears. When re-assembling, adjust the axle bearings to .001-.004" end play. Some guys adjust them to just take out all end play. Either way will probably be OK. May as well replace the felts while you are at it. Paul
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The 8N and the Fox - by Zane Sherman. Dec. 13 1998, Renfroe, Alabama. Last niht I dreamed about the day that I plowed the field of about 10 acres over on what Jimmy and Dandy called the Ledbetter field. I was driving the 1948 8N Ford tractor that Jimmy bought in 48 new This was prebably in about 1951 and maybe even befor the house was built. This would have made me to be about16 years old and I drove the tractor for nothing and would have paid to drive it if I had had any money which I didn't, but neit
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.