Posted by Don-WI on March 22, 2009 at 20:08:25 from (72.135.123.231):
This weekend I was just gonna replace the bushins where the axel pivots on our 1855 and call it good. The pin welded to the back of the wishbone on the back of the axel was worn, so I welded that up and since it's too big to be able to bring to work and machine it, I used the angle grinder to shape it. Better than doing nothing I guess.
Then after I got it back on, I noticed the spindles were kinda sloppy, so I took those out. The bushings were worn, as well as the actual spindles, so I took them apart today, finding that one bearing in one of the hubs is shot, and the seals are long gone.
I'm gonna see if they'll swing in the lathe at work, and if they do I'll build them up and turn them back down. Then I'll buy new hub seals, bushings for the spindle tubes, and the one bearing along with a tub of wheel bearing grease. I'll also drill & tap the hubs for grease zirks since they don't have any now.
The tie rod ends were also worn because they weren't tightened down enough before. I had the original tie rods around from my 1600 yet, so I put those on instead. They're a little smaller in diameter so they're not quite as strong, but it's better than having to buy all new ends, inner and outer, and trying to get them out of the tubes. I'll keep them around yet just in case, and I can still use the tubes. I still gotta remove the alternator and have it tested, because when I woke it up from it's hibernation it never started to charge.
What was a one or 2 day project has turned into a week long one, just to tighten the front end up a little.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Rescue of a Fordson F - by Anthony West. Introduction I live in the UK and have for many years restored Fordson tractors (in the main model N's). I have also restored and shown model F's, E 27N's, Field Marshall Series 2, David Brown Cropmasters and the old rey Fergeson T 20. At one time I had seven restored examples which were shown and used in ploughing matches. As most restorers, I have a number of war stories I can relate on a range of topics that may help other like minded and interested people. Perhaps my first p
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.