Posted by Walt davies on March 04, 2009 at 09:21:28 from (67.142.164.28):
In Reply to: R Aiken posted by Old Roy on March 04, 2009 at 08:58:58:
Roy, an easy way to find top dead center is to write down the firing order like 1-3-4-2 take the last half of the numbers an put them directly under the first half. The number that is directly under the top number is at the top when the other is. Turn it around till number 1 is at the top the watch number 4 (in this case) the valves should move up an down as you roll the engine back and forth stop when the two valves are just stopped at the closed position. this will be TDC on number 1. You can then check to see if the piston is at the top position if not the cam is out of time. Most older engines will time at 10 deg. before TDC and 30 deg. at full advance. If there is no mark on the front pulley then put a chalk mark at these two positions on the pulley and on the block for reference. I hope that this helps call me if you have trouble. Walt 503 623 0460
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Rescue of a Fordson F - by Anthony West. Introduction I live in the UK and have for many years restored Fordson tractors (in the main model N's). I have also restored and shown model F's, E 27N's, Field Marshall Series 2, David Brown Cropmasters and the old rey Fergeson T 20. At one time I had seven restored examples which were shown and used in ploughing matches. As most restorers, I have a number of war stories I can relate on a range of topics that may help other like minded and interested people. Perhaps my first p
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.