Posted by rick165 on February 13, 2009 at 14:55:41 from (66.82.162.19):
i bought a new motor/hydraulic pump for my kawasaki mule that dumps the bed.it is 12 volts the motor sets on top the pump it is all one unit about the size of a football.any way i wire it up to the toggle switch .the up position on the toggle switch is supposed to raise the bed and down lowers it.pretty simple operation.the motors wire leads are about a foot long where they connect the wires from the switch this is where i put my volt meter at i have 12 volts going to and threw the motor and back the other wire.so this tells me 12 volts is going to and in threw the motor and back out but the motor does nothing not even a hum.ar first i thought maybe it wasnt getting a good ground so i connected a jumper wire from one of the 2 mounting bolts directly to the negative side of the battery and still nothing.am i doing something wrong or did i just get a bumm motor. thanks RICK
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The 8N and the Fox - by Zane Sherman. Dec. 13 1998, Renfroe, Alabama. Last niht I dreamed about the day that I plowed the field of about 10 acres over on what Jimmy and Dandy called the Ledbetter field. I was driving the 1948 8N Ford tractor that Jimmy bought in 48 new This was prebably in about 1951 and maybe even befor the house was built. This would have made me to be about16 years old and I drove the tractor for nothing and would have paid to drive it if I had had any money which I didn't, but neit
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.