I think it was through a FarmShow article that I located a similar job done in Sheyboygan Falls, WI. Had noticed that many good repowers were done with 855s. Went to see the tractor, found his machinist who made the adapter plate, and he made one for me. That was something over $700 with heat treating- which is needed to relieve stress of drilling all the holes in the steel. Found a couple 855s on a neighbor's auction, had the best one rebuilt. Everything was rebuilt except the air compressor- mistake. Those bearings went bad after 4 days, took out the engine mains (common oil supply). Left the pump in because neighbor said he had an air-ride seat for me. Removed the pump, put in different accessory drive and remounted injector pump. Had to add a governor, front sump oil pan, extended the side frames with half-inch plate, heavy- half or 3/4 angle for the front mount. Put in a bigger radiator, although it now has the original back in. Custom made hood to cover the extended length. This was done in the mid- 90s, spent a few thousand on it. I still have oodles of notes, addresses, pix, etc. Machinist was Lee Sixel, in the Sheyboygan area. Actually never met him- did it all over the phone. email is open.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The 8N and the Fox - by Zane Sherman. Dec. 13 1998, Renfroe, Alabama. Last niht I dreamed about the day that I plowed the field of about 10 acres over on what Jimmy and Dandy called the Ledbetter field. I was driving the 1948 8N Ford tractor that Jimmy bought in 48 new This was prebably in about 1951 and maybe even befor the house was built. This would have made me to be about16 years old and I drove the tractor for nothing and would have paid to drive it if I had had any money which I didn't, but neit
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.