Posted by Janicholson on November 07, 2008 at 17:54:06 from (66.173.50.102):
In Reply to: Tricks posted by oldfrmer on November 07, 2008 at 17:17:26:
Pressure wash the bolt depressions (or wire brush and blow W/air. Remove all hitch linkages, springs, and seat. Dash components and materials in the way. Remove bolts. Attach Eye Bolts to threaded holes as will balance the weight. Lift with a cherry picker or ? not by hand unless there are at least 3 or 4 of you. Cautious wedging may be needed to break seal at gasket. Lift straight to keep from bending shift forks. Block it up, before setting it on the floor. Clean all gasket material off to metal. Blue rtv can be used for a gasket, be sure to go around the bolt holes. Use copper ring gaskets on the bolts for reassembly. JimN
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The 8N and the Fox - by Zane Sherman. Dec. 13 1998, Renfroe, Alabama. Last niht I dreamed about the day that I plowed the field of about 10 acres over on what Jimmy and Dandy called the Ledbetter field. I was driving the 1948 8N Ford tractor that Jimmy bought in 48 new This was prebably in about 1951 and maybe even befor the house was built. This would have made me to be about16 years old and I drove the tractor for nothing and would have paid to drive it if I had had any money which I didn't, but neit
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.