Well that sounds like about 3 loads on a big truck.So you would need to get about a foot of something over your culvert before you cross it with the truck.Back the first load in and cover the culvert,or cover the culvert with dirt about a foot deep at a place wide enough for the truck to cross,or dump the first load and spread it over the culvert with a loader or skid steer.Thats if I understand what it is you are asking.The main thing is to have the culvert covered by a foot of dirt(maybe even more) or something before you cross it.If its soft it would have to be spread backwards anyway.You might need to cover the culvert with dirt before the rock,or maybe a load of something other than big rock like waste or just dirt.Others probably will know better than me.While I have driven a dump truck,it was a long time ago,and I just drove and dumped it where they told me to dump it.Seems like culverts were covered about a foot with dirt,then rock on top of that,but it was 30 years ago,I could be wrong.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The 8N and the Fox - by Zane Sherman. Dec. 13 1998, Renfroe, Alabama. Last niht I dreamed about the day that I plowed the field of about 10 acres over on what Jimmy and Dandy called the Ledbetter field. I was driving the 1948 8N Ford tractor that Jimmy bought in 48 new This was prebably in about 1951 and maybe even befor the house was built. This would have made me to be about16 years old and I drove the tractor for nothing and would have paid to drive it if I had had any money which I didn't, but neit
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.