Posted by Jerry/MT on September 04, 2008 at 21:06:29 from (206.183.116.129):
In Reply to: MF65 stalling posted by pitchfork on September 04, 2008 at 19:12:24:
Just because you have all those new parts, don't assume that the ignition system is functioning properly. Test it to make sure.
Have you tried checking the spark by pulling the center wire out of the distibutor cap, holding it near a good ground and trying to start? You should have a FAT, BLUISH-WHITE SPARK, THE COLOR OF LIGHTNING ABOUT 1/4" LONG. If it's blue, reddish blue, or yellowish you have a weak spark. Check all the connection, make sure the points are clean and properly gapped, that you have battery voltage to the battery side of the coil with the points closed. If it starts running ratty, put a jumper across the ignition switch and see if that cures it. Ignition switches get high resisitance in them from dirty contacts and that can cause a weak spark. Make sure that you have the correct firing order. Check the timing with a timing light and verify that the advance is working. Are your wires copper core? They should be. Carbon core wires don't work well on tractors. Do you have the correct coil? If you have a 12 V system, you should be using a real 12V coil like a NAPA IC-14SB coil(~$15). It needs no separate resistor. If you have 6V coil on a 12 V sytem, you'll need a resistor to drop the voltage at the coil terminal to 6V to limit the primary current to 4 amps max or the coil will overheat and eventually burn out.
Make these checks sytematically, checking for effect any time you change anything.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Harvestin Hay: The Early Years (Part 2) - by Pat Browning. The summer of 1950 was the start of a new era in farming for our family. I was thirteen, and Kathy (my oldest sister) was seven. At this age, I believed tractor farming was the only way, hot stuff -- and given a chance I probably would have used the tractor, Dad's first, a 1936 Model "A" John Deere, to go bring in the cows! And I think Dad was ready for some automation too. And so it was that we acquired a good, used J. I. Case, wire tie hay baler. In addition to a person to drive th
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.