I've had a similar problem with my 664. I assume this is a baler with AutoWrap. On the right hand side, under the shield (near the pulley that drives the AutoWrap gearbox), there is a plastic brush for a shield that covers a disk that rotates as the twine tie runs. You should be familiar with this area since there is a grease fitting in back there. This rotating disk has an off center stub shaft. A cast iron arm mounts on this stub shaft and is held in place with a flat washer and a cotter pin. The other end of the cast iron arm has a spring hooked to it. The arm has to be pulled back by the spring to stop the tie cycle. On my baler the shaft gets rusty and the arm seizes up. Spraying penetrating oil did not fix mine. I had to remove the arm and clean the shaft up with emery cloth.
I apologize if my descriptions are not very clear . If you can't get figure it out, post back and I will take some pics to make it clearer.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Chores - by Frank Young. The ceaseless passing of time! It is at once our friend and our enemy. It measures our progress and it makes us old. Like most features of our life, few things are all good or all bad, and most such judgments depend on our own perspective or viewpoint. In our particular hobby, we enjoy the nostalgic return to the days of our youth as we recreate many of the scenes that took place on the family farm that served as the stage for the first few acts of the play that is our live
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.