Posted by Fla Farmer on March 30, 2008 at 08:43:09 from (204.49.132.156):
Hate to display my ignorance yet again - BUT need information on how to set up my disk for various purposes. Inherited an old 10 ft. disk from my dad, not drag type. Switching positions on the tiers of blades is accomplished by pulling a pin from the top of the disk and using a heavy hammer or,in my case, a heavy fence post to drive the tier to another position, either angled or straight. I want to cut my garden so that it buries the weeds, but doesn't leave big gouges in the field. THEN I want to change positions and make another pass to level the field for planting. I don't know how to set the blades to make this happen, OR how to level the disk. I do know enough to lengthen the top link so lower the front end. Advice most welcome. Thanks. (Think I'll change my sign in to "Fl. Ignoramus").
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Rescue of a Fordson F - by Anthony West. Introduction I live in the UK and have for many years restored Fordson tractors (in the main model N's). I have also restored and shown model F's, E 27N's, Field Marshall Series 2, David Brown Cropmasters and the old rey Fergeson T 20. At one time I had seven restored examples which were shown and used in ploughing matches. As most restorers, I have a number of war stories I can relate on a range of topics that may help other like minded and interested people. Perhaps my first p
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.