Tractor Talk Discussion Board |
Jubilee rebuild
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by jubileejim on July 09, 2007 at 18:25:43 from (76.104.217.44):
I have a Jubilee ran several years ago but had to leave it for several years. It would not start, then found it had a stuck valve, on number two cylinder. Took the head off cleaned and reseated the valves. Took compression test, but only came up to 30 to 40 lbs per cylinder. I put motor oil in the cylinders, and did the check again they came up to 50 to 60 lbs per cylinder. So now I took the engine out pulled the pistons but three of the four pistons looked to have good rings, number four stayed compressed, I assume from carbon build up. I"m no mechanic, but when I took the head off I had oil on the head gasket where I didn"t think it should have gotten because I did tighten to the torque spec. 70 lbs. Any suggestions or thoughts on this?
Replies:
Home
| Forums
Today's Featured Article -
Chores - by Frank Young. The ceaseless passing of time! It is at once our friend and our enemy. It measures our progress and it makes us old. Like most features of our life, few things are all good or all bad, and most such judgments depend on our own perspective or viewpoint. In our particular hobby, we enjoy the nostalgic return to the days of our youth as we recreate many of the scenes that took place on the family farm that served as the stage for the first few acts of the play that is our live
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|