Tractor Talk Discussion Board |
Re: Snowplow truck hydr. problem
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by J Schwiebert on December 06, 2006 at 17:32:55 from (209.143.51.248):
In Reply to: Snowplow truck hydr. problem posted by Roy Suomi on December 06, 2006 at 16:46:41:
Oh the problems of a former life time! Have you had the pump off and inspected the inside of the pump? Is this a P20 pump and then what width gears or what is the width of the center section? Are you putting stress on one side of the pump shaft because of belt tension? Two other comments. A common cause of front seal failure on a gear pump is too much internal pump leakage. Can you load test the pump? Next thing , this was true with Gresen and I am sure it was with Commerical since that was their major competitor (now also part of Parker) can you get a front seal for a M-20 motor if that is what you have? Motor seals for the output shaft are designed for higher flows and pressures. How much pressure do you run when the control valve is in neutral? Do you need a comerical shop manual for that pump? I should have some left. More questions? J.
Replies:
Home
| Forums
Today's Featured Article -
The Rescue of a Fordson F - by Anthony West. Introduction I live in the UK and have for many years restored Fordson tractors (in the main model N's). I have also restored and shown model F's, E 27N's, Field Marshall Series 2, David Brown Cropmasters and the old rey Fergeson T 20. At one time I had seven restored examples which were shown and used in ploughing matches. As most restorers, I have a number of war stories I can relate on a range of topics that may help other like minded and interested people. Perhaps my first p
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|