Tractor Talk Discussion Board |
Re: Question for Hydraulics expert
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Old Pokey on August 26, 2006 at 21:01:17 from (216.99.197.244):
In Reply to: Question for Hydraulics expert posted by Double M on August 26, 2006 at 20:43:11:
No problem. The cylinder will get plenty of oil for lube. You can buy a screw in filter for that purpose from any hydraulic retailer. They're sometimes called a "muffler". Dont know why they call it that, but when I ask for a cylinder muffler, the parts guy can find it in the book a lot faster. Something you might even consider since the cylinder will wear over time, is to run a pipe or hose from the end you put the muffler on down to a place where any oil that gets by the seals wont splash all over the tractor, or worse, you. Then put the muffler on the end of the pipe or hose.
Replies:
Home
| Forums
Today's Featured Article -
Gatherin of the Orange - by Rick Nikolich. In July of 1998 I was talking to fellow Allis Chalmers collector Mike Schilling about the annual "Gathering of The Orange" AC show coming up in August of 1999. He got this wild idea that we should get a convoy of AC tractors and drive them from Charlotte, Michigan 105 miles to LaGrange, Indiana.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|