Tractor Talk Discussion Board |
Re: Finding TDC of Number one Cylinder
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by wdtom on December 05, 2005 at 17:21:15 from (155.212.222.225):
In Reply to: Finding TDC of Number one Cylinder posted by Monte Hewuse on December 04, 2005 at 18:05:53:
I don't knowhow accurate you want to be but to find TDC the easy way is to pull the plugs, stick something into no. 1 that will not hurt the threads in the plug hole, will contact the piston as it is slowly brought up by you turning the engine over slowly. You turn in one direction until you bump the stop. Mark the flywheel or crank pully. Now turn the other way until you again bump the stop. Mark the flywheel or crank pully again. Half way between the two marks is TDC. You must not let the stop you put into the cylinder move while you are doing this procedure. The hot rodders and other engine builders use this method to degree in camshafts. Only they bolt a stop over the piston before the head is on and use a degree wheel temporarly mounted on the crank.
Replies:
Home
| Forums
Today's Featured Article -
The Rescue of a Fordson F - by Anthony West. Introduction I live in the UK and have for many years restored Fordson tractors (in the main model N's). I have also restored and shown model F's, E 27N's, Field Marshall Series 2, David Brown Cropmasters and the old rey Fergeson T 20. At one time I had seven restored examples which were shown and used in ploughing matches. As most restorers, I have a number of war stories I can relate on a range of topics that may help other like minded and interested people. Perhaps my first p
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|