Tractor Talk Discussion Board |
epoxy- no way
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by LK on September 23, 2005 at 09:32:13 from (64.236.208.25):
In Reply to: Re: gas tank welding- fill with water? posted by 550Doug on September 22, 2005 at 17:48:20:
Somebody tried epoxy on this thing. I can tell by looking at it that i could probably get epoxy to seal ok, but I really need to get the old strainer unthreaded from the tank. No way that epoxy would get enough of a grip on the small threaded insert to hold it still while I turn the old strainer out with a pipe wrench. I cannot even remove the heatshield until i do this. And the strainer is likely not even salvagable- I'll see if i can, but I need to get it off first. So it really demands getting down to bare parts and restoring properly. Once I fix the threaded hole, I'll clean the inside of the tank and coat with that sealer stuff. Then blast, prime and paint the outside of the tank. I can't believe John Deere didn't feel it neccessary to put any paint at all on the tank- sure it is hidden from view, but that doesn't mean it wont rust!! Me neighbor's A had a 6" rust hole in the TOP of the tank- probably a mouse nest held moisture there for years and it rusted. The tank has not had any gas in it for about 20 years and there is absolutely no odor of gas, by the way.
Follow Ups:
Home
| Forums
Today's Featured Article -
Gatherin of the Orange - by Rick Nikolich. In July of 1998 I was talking to fellow Allis Chalmers collector Mike Schilling about the annual "Gathering of The Orange" AC show coming up in August of 1999. He got this wild idea that we should get a convoy of AC tractors and drive them from Charlotte, Michigan 105 miles to LaGrange, Indiana.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|