Tractor Talk Discussion Board |
Re: how they angle Wing plow on large plow trucks
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Mark - IN. on March 04, 2005 at 22:08:34 from (64.12.117.7):
In Reply to: how they angle Wing plow on large plow trucks posted by diggerdave on March 04, 2005 at 07:15:30:
Funny you should ask Dave, just gave one a good looking over the other day. Was a 5 ton state truck and was leaning on the blade. Blade had one push-pull cylinder on each side of the blade, and one large cylinder to lift and lower it. The thing that amazed me was the 3/8" cable between the cylinder and the blade that lifted and lowered it. That was a huge blade, and I'm sure that cable gets stressed out like no one's business. The cable locks are the same exact ones that we use for the cables that we use to anchor utility poles. We use 2 on each end of the cable, the truck used 3. Obviously 3/8" cable is much stronger than I ever gave it credit for. Then again, maybe used to be 1/2" cable when it started out. Hmm? Naw, locks were tight at 3/8". Mark
Follow Ups:
Home
| Forums
Today's Featured Article -
The 8N and the Fox - by Zane Sherman. Dec. 13 1998, Renfroe, Alabama. Last niht I dreamed about the day that I plowed the field of about 10 acres over on what Jimmy and Dandy called the Ledbetter field. I was driving the 1948 8N Ford tractor that Jimmy bought in 48 new This was prebably in about 1951 and maybe even befor the house was built. This would have made me to be about16 years old and I drove the tractor for nothing and would have paid to drive it if I had had any money which I didn't, but neit
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|