Tractor Talk Discussion Board |
Replacement hardware for Loaders
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Paul_NJ on February 24, 2005 at 20:58:21 from (70.21.244.125):
I just bought a 1701 loader for my International 340. Got a good price ($350), but it's pretty rusty from sitting outside. Arm cylinders are fine, but the bucket cylinder leaks and needs to be rebuilt. But that's all do-able. Here's my problem: the holes the pins go through where the arms pivot to the frame are worn and elongated from wear. The pins are almost falling out. I've been told that this is a common problem with used loaders and backhoes and that replacement pins and bushings can be purchased. Apparently you weld the bushing plate over the top of the old hole. Does anyone have experience doing this? Where would you find parts such as these - I assume they are generic and not necessarily IH items.
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Proflie: John Deere Model R - by Staff. The John Deere Model R, the last of the lettered tractors, was the first diesel-powered tractor produced by John Deere with a gasoline starting engine. It was also the first tractor they produced that had an optional steel cab. The photo above shows the tractor w
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|