Tractor Talk Discussion Board |
Re: Propane Vapor Pump
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by John A. on January 21, 2005 at 15:06:22 from (65.161.170.165):
In Reply to: Propane Vapor Pump posted by Bob Akers on January 21, 2005 at 14:04:08:
Bob, I don't follow why you would need a pump to assist in filling your tank. Simply hook up the liquid fill hose from the nurse tank to the fuel tank on the tractor. Get a "Bleeder" this can be obtained from your local LP dealer. Thread it on the vapor valve. Screw it on just enought to release the vapor pressure. If you screw it in too far, (opening the valve, the overload trip will shut it off, simply start over and don't screw in as far). At sone point the vapor pressure will get lower than the pressure in the nurse tank. Let the vapor bleed off, till liquid starts comming out. Shut off the Bleeder. Shut off and remove the liquid hose, and you are good to go!. Hope this helps! Later, John A.
Follow Ups:
Home
| Forums
Today's Featured Article -
Gatherin of the Orange - by Rick Nikolich. In July of 1998 I was talking to fellow Allis Chalmers collector Mike Schilling about the annual "Gathering of The Orange" AC show coming up in August of 1999. He got this wild idea that we should get a convoy of AC tractors and drive them from Charlotte, Michigan 105 miles to LaGrange, Indiana.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|